If you have not moved the factory setting of lower bolt (leave as is).
If you loosen off tension handle until you can just move the bar by hand (0 clearance so to speak)Tighten to point you cannot slide by hand (at this point the movement of handle will have been very little )
Make a mark on for future reference showing you where the point of friction begins. From this point tighten the handle 1,1/2 to 2 turns. This is most times sufficient.
Remember to back off tension to 0 or better yet remove friction bar before you start backing in sharp turns at your campground. HTH
__________________
2011 325SRX , Mor-Ryde Pinbox
2004 Ram 3500DRW 6spd,4x4,QC.LB ,340L aux tank
1999 Concours
2014 FJR
2014 Jetta TDI
|