TST TPMS repeater wiring to Montana Giggy Box

[Mikenjulie]

I'm getting ready to install my TST TPMS. Do any newer Montana owners have a picture of how the factory wired your repeater to the Giggy box?

Thanks,
Mike

[ChuckS]

All that is needed is mount the repeater to the inside wall of froward compartment or hydraulic compartment close enough so the wire harness from repeater will reach Giggy box

Pic shows pin out inside the box.. wire to incoming battery and ground

Yes the repeater is active all the time and that is what TST recommended .. mine has been connected for going on 3 years now directly to the battery and ground. Amp draw is insignificant

[jxnbbl]

I originally put a switch on mine mounted to the battery box. When I got a new trailer, I just wired to the battery through the giggy (sorry I don't have a picture) and it draws whenever the main giggy switch is on....never have had a problem.

[Mikenjulie]

Originally Posted by ChuckS

All that is needed is mount the repeater to the inside wall of froward compartment or hydraulic compartment close enough so the wire harness from repeater will reach Giggy box

Pic shows pin out inside the box.. wire to incoming battery and ground

Yes the repeater is active all the time and that is what TST recommended .. mine has been connected for going on 3 years now directly to the battery and ground. Amp draw is insignificant

Thank you. That’s what I was thinking.

[Mikenjulie]

Originally Posted by jxnbbl

I originally put a switch on mine mounted to the battery box. When I got a new trailer, I just wired to the battery through the giggy (sorry I don't have a picture) and it draws whenever the main giggy switch is on....never have had a problem.

Thank you. Now I have a plan.