I made it with one universal vehicle end, a vehicle end mounting bracket, 3 small pieces or wire, and a round switch. Power is from the auxiliary terminal, load is the tail light terminal and then ground is the third so that the red light comes on when the switch is turned on. I had to drill the back of the vehicle end because the switch is 15/16. A little RTV to seal ot and you are good to go. Can be done with a two post switch also. Got all the parts at a local auto parts store.
__________________
R.J. and Ginger
2019 Ram 3500 6.7 HO, Aisin Trans 3:73
Reese Goosebox
2019 Sandpiper 379FLOK
|