Vent Fan Wiring

[dmullen]

I am putting a Fantastic Vent in the factory location in my 2014 Bullet 246RBS. I removed the trim piece to make sure I had a wire to tap into and this is what I found...


Did I get lucky and Keystone pre-wired the vent area?

[PARAPTOR]

Now the game begins !!! Where is the other end?? Do not assume anything After crawling around in my Raptor, Not sure the type beverages in the factory floor vending machines

[JimDogs]

Check the wires with a simple 12V test light, positive/negative to insure it is not a 120V wire. Looks to me as though it is a lucky day for you!

[dmullen]

I guess I wasn't so lucky after all. I started to pull on the wire a little to get some slack and it fell out! It was just a 2-foot piece of wire not attached to anything.

Looks like I will be tapping into the light after all.

[dmullen]

I hard wired a Progressive Industries EMS into my Bullet with no problem. I replaced the mouse hole with a shore power socket with no problems.

Now I am trying to tap into the light fixture next to my new Fantastic Vent and I am confusing myself on something this simple. There will be 3 wires going into each wire nut right?

[scott24]

Originally Posted by dmullen

I hard wired a Progressive Industries EMS into my Bullet with no problem. I replaced the mouse hole with a shore power socket with no problems.

Now I am trying to tap into the light fixture next to my new Fantastic Vent and I am confusing myself on something this simple. There will be 3 wires going into each wire nut right?

You hit the nail on the head. 3 wires in each wire nut.