This weekend we installed a 32" Tv on the center console. We decided that a mirror was not need in this location and also enabled the Kids to watch TV in the main room and still have a TV in the bedroom.
what you will need
1. 32" TV or Smaller. Max height restriction 22"
2. 32" TV wall mount Bracket. (monoprice PID-7847 $25 inc shipping) or like.
3. 3 x audio Y-Cable (RadioShack $4:99) This will enable you to watch a DVD on either or both TV's.
4 1 X3' component cable (red/white/yellow)
5. 1 x 4' coax cable.
6. 1 coax splitter.
7. very short coax cable for splitter.
8. Bolts 2" X 3/8 plus washer/locking washer and Nuts.
Installation.
1. Turn 19" tv to the Bedroom
2. Remove the mirror.
3. Remove 19" TV from mount locking bracket screw is accessible though hole in back. lay tv on bed.
4. Run second coax and power down though pipe and hole in board. Run any other cable that you may need (HDMI).
5. Re-install 19" tv bed room side
5. remove Jensen Radio.
6. Drop audio/video cable down from top
7. locate the video and audio out cable on the back on the Jensen System install the Y-Cable and re-attach the original audio/video cable and the new one. (this will depend on the TV bracket)
8. Re-install Jensen Radio
9. From top of opening measure down between 6" and 7" on both sides. (This distance may change with different brackets)
10. Drill to holes about 1/2 in from each side.
11. put bracket up with two bolts just in the holes. Then Make second hole on each side.
12. Take down bracket and drill second lot of holes.
13. Clean/vacuum up the mess 19" TV will still swivel.
14. lock 19" TV facing bedroom.
15. install new TV bracket with bolts.
16. Measure and and install brackets on back of TV.
17. Test mount TV and adjust if needed.
18. Have somebody hold TV install all of the cable on the TV and mount TV on wall Bracket.
19. Install coax splitter in cabinet at top.
20. Open a beer and enjoy the new TV.