Adjusting the cables on the slide

[Kenny mill]

Greetings,


We have a 2018 keystone cougar 30rkswe, the cables are loose and have watched a video on how to adjust the cables, fairly straight forward. My issue is how do I get the trim piece off? Do the three small pieces come off and then there are screws behind that? Is the whole piece stapled on with some glue?

I don't want to damage the trim piece but I cannot get to the cable adjustments with the trip piece on. I tried taking a wide putty knife to the small squares but they didn't seem to budge and I was hesitant that I could damage them.

Thanks for all your help, you all are the best.



Kenny

[chuckster57]

You only need to remove the TOP facia, the top layer will be brad nailed. If you have a center piece the front and rear facias will have a gap. You might want to label and mark them so they go back on in the correct position. The particle board piece is screwed in place and may take 2 people depending on the length. phillips if I remember right. We use 18ga brads to reattach the top layer.

[Kenny mill]

Thank you Chuck, ours is a one piece the full width.

[chuckster57]

I use plastic windshield tools to pry off the outer layer