Open Neutral - 3590RS

[Simslock]

I have a 2016 Alpine 3590RS and have an open neutral on the bath/linen slideout that affects the two GFI circuit outlets (one in bathroom and one in closet). All other GFI outlets work fine. I cannot seem to trace where the affected outlets cable enters the slide. I removed the ledge on the inside of the slide and there are two 120 v wires but they wseem to be connected to the slide mechanisms.
From the GFI breaker on the converter panel the wire heads into the ceiling and the only GFI plug with a breaker is by the sink, but all are on the same main breaker.
Anyone have any advice.

[chuckster57]

Slide motor will be 12VDC. 120VAC is usually a round 3 conductor cable, not Romex. It will be Romex in the underbelly, then attached to the flexible cable using a “molex” plug. Once inside the slide another molex plug will change it back to Romex.

https://images.search.yahoo.com/imag...ne&fr2=piv-web

[Simslock]

Thanks for the reply. I did see molex connectors on the slide so should be able to trace which one might be the culprit. I will likely work on it tomorrow

[Simslock]

I haven't gotten around to replying until now but the issue was a bad connection in the molex connector. Problem solved. Thanks for the help.