How did you reset thenIn Command system ? If you only pressed the reset button on the BCM it most likely won’t help
Do a hard reset.. if not already done
You must
.. turn off the display commander and BCM
.. disconnect battery cable .. using battery disconnect won’t work as BCM is hard wired
..disconnect shore power
Why?
This remove the 12 volt output from converter to the roof AC control boxes and will often let them and gateways reset the internal relays
Wait a minute or two and then
.. reconnect battery lead
.. turn BCM and display on
.. apply shore power
Observe if the HVAC zones now display an actual temp reading instead of the - symbol
If temp now shows operate each zone and observe operation
__________________
2007 GMC Classic club cab 4x4 Duramax LBZ
2014 Alpine 3010 RE. 34 foot fifth wheel
|