|
03-25-2019, 08:14 PM
|
#1
|
Junior Member
Join Date: Mar 2019
Location: Huntington Beach
Posts: 8
|
Furrion Back Up Camera
I have a 2019 Passport 199 MLWE and just purchased the Furrion S back up camera , Plug and Play they say but not so much. No power to the cable coming from the trailer. Anyone have any suggestions on where or what fuse this might be attached to?
The camera is working as i synchronized it to the display. Plugged in my 7pin trailer connector and all good with the running lights on the trailer but nothing to the camera . Not sure what else to do ?
|
|
|
03-25-2019, 08:21 PM
|
#2
|
Senior Member
Join Date: May 2018
Location: Phoenix
Posts: 352
|
Did you manually switch heads lights or parking lights to the truck on?
|
|
|
03-25-2019, 08:39 PM
|
#3
|
Junior Member
Join Date: Mar 2019
Location: Huntington Beach
Posts: 8
|
I did, first started with the running lights then headlights and finally put it reverse, nothing seems to power it up
|
|
|
03-25-2019, 09:45 PM
|
#4
|
Senior Member
Join Date: Mar 2017
Location: Colbert
Posts: 248
|
And you do have your trailer batteries connected with the battery disconnect switch turned on? Some of the Keystone camera wiring goes through the Converter DC fuse box and has nothing to do with the truck wiring or pigtail.
__________________
2017 Avalanche 320RS 5'er
2022 Ford F-350 Lariat Ultimate with 6.7L Diesel
Andersen Ultimate 5th Wheel hitch
|
|
|
03-25-2019, 09:46 PM
|
#5
|
Senior Member
Join Date: May 2018
Location: Phoenix
Posts: 352
|
Does your trailer have a battery shut off on one of the storage side compartments? If so could it be in the off position; recheck the Furrion plug & play connection; finally the fuse panel inside the trailer?-weird
|
|
|
03-25-2019, 09:49 PM
|
#6
|
Senior Member
Join Date: May 2018
Location: Phoenix
Posts: 352
|
Also that cigarette power outlet adapter from the Furrion to the truck could be faulty...can't remember if it has a fuse in it?-check that bad boy out.
|
|
|
03-25-2019, 09:54 PM
|
#7
|
Senior Member
Join Date: May 2018
Location: Phoenix
Posts: 352
|
I'm sure you've been all over that trailer-lol (not funny when it's happening to you)
It can't (can it?!) really be any other variables that I can think of?
|
|
|
03-26-2019, 08:41 AM
|
#8
|
Senior Member
Join Date: May 2018
Location: Phoenix
Posts: 352
|
Ok Jason.....what did you find out?! And yes the Furrion has a fuse in the power/cigarette power plug in.
|
|
|
03-26-2019, 08:32 PM
|
#9
|
Junior Member
Join Date: Mar 2019
Location: Huntington Beach
Posts: 8
|
Meza93 thanks for the info,
I couldn’t find a battery disconnect switch anywhere , I do get power from the battery to the trailer . I don’t know where it would connect into the fuse box other than the 3w fuse for the running lights on the trailer . The cigarette adapter in the truck is good , I was able to sync the camera through the car
One thing that I did notice is the model recommended on the trailer camera mount is the FOS48TA-BL however I got the FOS43TASF, I called Furrion today and they said that shouldn’t be an issue as its basically the same camera, one model comes with the housing and the other doesn’t . My only thought at this point is they never connected the Pre wire cable to anything.
|
|
|
03-26-2019, 08:44 PM
|
#10
|
Senior Member
Join Date: May 2018
Location: Phoenix
Posts: 352
|
I think its time to take it to a Keystone Dealership and have them check it out especially since you are using the rewired factory location and a Furrion....I think your right about it not being wired to power. Try running an experimental power wire from your trailer taillamp to the camera? At least power it up from the trailer, than you will know for sure...
Maybe first see if the Stealership will fix it under warranty since its suppose to be plug & play
Keep us in the know-lol!
|
|
|
03-26-2019, 08:54 PM
|
#11
|
Junior Member
Join Date: Mar 2019
Location: Huntington Beach
Posts: 8
|
Love that seat too meaz93 , Lol !!!
|
|
|
03-26-2019, 08:56 PM
|
#12
|
Senior Member
Join Date: May 2018
Location: Phoenix
Posts: 352
|
I'm all about multitasking-lol
|
|
|
03-30-2019, 03:54 PM
|
#13
|
Junior Member
Join Date: Mar 2019
Location: Huntington Beach
Posts: 8
|
‘UPDATE’ !!!! So I pulled off the light above the Furrion Pre Wire hookup ( for the camer ) and discovered that Keystone incorrectly wired the back up camera connector. It was a quick fix at that point . Thanks again meaz93 and John&Jenny for your help
|
|
|
03-30-2019, 03:59 PM
|
#14
|
Senior Member
Join Date: May 2018
Location: Phoenix
Posts: 352
|
Niiiicceeee, thankful for a quick fix ehh!
"Paper or Plastic" on the installer?
Holy crap-lol
|
|
|
04-11-2019, 07:58 AM
|
#15
|
Junior Member
Join Date: Nov 2018
Location: Union
Posts: 17
|
On my trailer, the power is run from the center running light. If yours is the same, check to make sure your running light near the camera is on. If it is and you still have no power to the camera, pull that light and see if the connection is made or take the connection apart at the power plug to make sure it is wired right.
Sorry, all the posts did not load on my pc until after I posted. Glad you found it.
|
|
|
04-11-2019, 08:11 AM
|
#16
|
Junior Member
Join Date: Feb 2019
Location: Sherman Oaks
Posts: 2
|
Check the wiring that is tied into the running light for power & ground. Mine was wired backwards on my 2019 269rlswe.
|
|
|
04-11-2019, 08:23 AM
|
#17
|
Senior Member
Join Date: Mar 2017
Location: Colbert
Posts: 248
|
Quote:
Originally Posted by Jason stapleton
‘UPDATE’ !!!! So I pulled off the light above the Furrion Pre Wire hookup ( for the camer ) and discovered that Keystone incorrectly wired the back up camera connector. It was a quick fix at that point . Thanks again meaz93 and John&Jenny for your help
|
You would think it wouldn't be that hard to connect two wires with just a positive and negative, hell, they had a 50/50 chance even if they didn't use a voltmeter. Really, that's pretty sad and speaks volumes about the RV industry.
__________________
2017 Avalanche 320RS 5'er
2022 Ford F-350 Lariat Ultimate with 6.7L Diesel
Andersen Ultimate 5th Wheel hitch
|
|
|
04-11-2019, 01:06 PM
|
#18
|
Junior Member
Join Date: Dec 2018
Location: MURRIETA
Posts: 19
|
Camera
Quote:
Originally Posted by Jason stapleton
I have a 2019 Passport 199 MLWE and just purchased the Furrion S back up camera , Plug and Play they say but not so much. No power to the cable coming from the trailer. Anyone have any suggestions on where or what fuse this might be attached to?
The camera is working as i synchronized it to the display. Plugged in my 7pin trailer connector and all good with the running lights on the trailer but nothing to the camera . Not sure what else to do ?
|
I had the same issue and they had the positive and negative reversed. I had to take off mounting bracket and pull wires out and reverse them.
|
|
|
04-12-2019, 06:42 PM
|
#19
|
Member
Join Date: Aug 2017
Location: Warrensburg
Posts: 32
|
My Furion is powered off the running lights and obviously they have to be on for the camera to work. You said your running lights are ok so I am at a loss as to how your trailer is wired.
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|