will can am sxs fit in 2014 fuzion 301?

[kpete6]

Hello everybody! I am picking up a new fusion 301 in a week and am now doubting if my can am commander xt will fit...I know kinda late now but did my measurments and it looks tight but doable. However after reading through the forums I am getting a mixed bag of answers to this question..lol! Does anybody have this combo and or know anyone who does?? Thanks!

[crash]

Sorry we cannt help you on that one we have a 384pk Raptor now I could tell you it would fit in that one we have a 14 ft garage

[Essness]

I bought a 27FS as it was the most logical fit for what we needed and wanted. Unfortunately, it has a 9 foot garage and our highly modified golf cart is 10 foot long.
before we made the purchase I found a way to make the cart 1 foot shorter for transport.
I need to remove the front brush guard (2 bolts) and flip the dump bed backwards, (2 bolts). The dump bed is electric and once the bolts are removed it raises in this position.



it travels well and takes about 5 mins to get ready on either side.

So, even if it doesnt fit on paper, you can looks at some more creative ways to fit it.
again, the 27 FS was our most logical fit for a myriad of reasons, so modifying the length of the cart just made sense.

[kpete6]

thanks guys I have a few ideas to use if I have an issue. By manufacturer specs from keystone and canam I should have an 1 1/2" to spare on length but you know how those things sometimes go! Lol! Hoping someone out there had actually tried it...I'll keep checking back.

[spicercars]

I would say it might be a very tight fit if it will fit at all. The 301 has a 10' garage. My raptor has a 12' garage and my 2013 Polaris 900xp ranger fits but does not have very much extra room. Good luck.

[abneynormal]

I have a 3912. the garage is 12 feet long by 8 feet. we get my 900 Vulcan lt and my dads 800 "tramp" leighman trike in ours. if the can am isnt over 11 feet long it should work if you have a 12 foot garage.

[rnkburg]

I have the raptor 300 mp and looking for a sxs as well. I had to eliminate the can am because it was too long for the 10' garage. I am thinking a teryx, rzr , rzr s, rzr xp will fit , new yamaha won't , 4 seaters are out and rzr 1000 is out. I am going to try to load my sxs of choice in raptor before I purchase it

Sent from my EVO using Tapatalk 2

[kpete6]

The commander xt is 118.5 inches long which would be just shy of the 10' garage at 120 inches..if the specs are true for both! lol! If not I think I can buy some car ramps and run the front end up to gain extra room for the length. I think the height of the bunks in the 301 may give me some issues though. I would hate to remove one of them but may have to. Will post when I get the new fuzion home and do the fit test and what I did to make it fit. Where theres a will theres a way right??

[rwmurphy15]

Kpete6,
I am also picking up a new 2013 Fuzion 301 and I have a RZR. When I was at the dealership I measured the garage over and over. My RZR is 69" high stock and I added a roof. The height to the first of 2 bed brackets is 71" but the problem might be going up the ramp at a angle and hitting the bed brackets. So I'm thinking of removing the bottom bed so it gives me more head room for the RZR. I'm also getting a 5'x 8' alum trailer from Walmart and sliding it in sideway beside the RZR by removing the tires and one fender and the tongue rail. I want to take a trailer along to campgrounds that don't have trail access where I have to trailer my RZR to riding areas. So I need all the garage I can get. I think you will be OK you might like me have to remove the bottom bed. Let me know how you make out.

[rwmurphy15]

One more think I hope you noticed that the garage is only 9' 9" not the 10' they claim it's suppose to be.

[spicercars]

You also need to keep in mind the things move a little even if there strapped down so if it is a tight fit the machine might end up hitting or rubbing on something. The other thing to keep in mind is the weight. You will have major problems if you put to much weight in the back.

[Vidorcom]

Height is 75 and weight is 1295. Your fine, but no wiggle room in the 9'9 Garage.

[JBon]

Our Can-am commander barley fits in the fusion 342 (12' garage) not sure if Can-am will fit in a 10' garage, have to consider front bumper w/winch. definitely measure the Can-am and trailer, don't take the manufactures word for it.

[Big Boy w/ Big Toys]

I have a 10' garage on my Raptor 30FS and I get my Arctic Cat Wildcat in with a hair to spare, but has to be stock tires, no bumpers, and no winch fair lead.

[kpete6]

Wow! Do you have the X or the xt?

[Vidorcom]

Drag into Moses Lake and say your interested in buying but you want to make sure it fits.

[Big Boy w/ Big Toys]

Originally Posted by kpete6

Wow! Do you have the X or the xt?

No I have the 2012.

[JBon]

have a 2012 can am commander xt1000

[kpete6]

Ok so I got my fusion home and nope it did not fit! Height under the beds was fine but the garage is in fact not 10' it is actually 9' 9"! I called the dealer and they are working with me to build a recess into the back wall and line it with diamond plate. They are contacting the keystone rep to either pay for it or help the dealer with the cost! Word to the wise...never let the salesman run the smart end of the tape when measuring things! lol! Thanks everybody for the responses to my question!

[Vidorcom]

Keystone pay for it? That will be amazing. Recess in the front wall sharing Bathroom? There is no much if any room. Keep me posted as we just purchased a Maverick. I have a sleddeck in the bed of my truck i could put on but would be nice to put in Toyhauler