I have pre-wired mine in my recent new Premier 19 until I get the fan in USA. I saw pictures somewhere and install like this:
[/LIST]Remove the vent shroud[/LIST]Drill 3/4" hole on left side of vent blocking towards microwave.
- Remove microwave and unplug.
Drill another 3/4" hole on left side of ceiling in microwave cabinet.
- Use 12 gauge Red/White wire and coil along a coat hanger with tape at the end only, and fish from vent to microwave.
Go slowly as not to put a hole through ductwork.
- Use screwdriver to feel around for hanger and remove tape and pull wire down.
Make sure you pull fuse 3rd up from bottom before connecting wires. Red is hot, and fan will specify hot wire. Fairly easy job of less than 30 minutes. Use proper splice connectors for 10/12 gauge, and ensure connection is firm. Install microwave again.