Quote:
Originally Posted by AnolaBob
I should be more clear. The vent areas themselves have been weakened by the movement of the vent covers and the lack of solid wood support around the vent holes. I will rebuild those areas prior to the installation of the flooring.
|
OK, you've got a world of flooring choices then. Vinyl is always good. Since it is a relatively small area, even the high end stuff would not cost very much. Color and texture and design is a personal decision. Personally, I'd be looking at the Armstrong middle grades.
Square vinyl tiles are OK, especially for DIY, but they tend lift around the edges over time. Not my choice at all, but some DIYers swear by them in RV's.
Some of the laminate flooring choices would be real good, provided you can install it without issues involving the slides. Laminate is easy to DIY, but stay away from the nail down or glue together versions. Snap together floating is the way to go.
And there is always carpeting. Not my choice for the entry way, but that's a personal choice again. If I was doing carpeting, I'd stay away from shags, at least in the living areas. Either real short fibers or high end indoor/outdoor would be my choice. Bedrooms might get something plusher and more cushioned.
All of this stuff is readily available at any home improvement or flooring store.
I'd step up to better quality floor vents, too. If you can't find the exact right size at a home improvement center, consider something close. You're going to be tearing out the old vinyl and rebuilding the subfloor around the vents anyway so if you had to resize the openings a bit to accommodate something you really like, I don't see any reason you should not do that. I am going to replace all the floor vents in the Cougar this year. The cheapie stamped ones are not kind to bare feet and they tend to bend almost immediately.