2011 303TG Fridge drain

[DTJ9610]

Does everyone with the 303TG have the tube that sticks out of the fridge vent for condensation draining. It appears mine is coiled to high and does not drain. In turn the little catch dish inside the fridge overflows and the watter just drips into the fridge. Bythe time I figures it out the fridge coild were to hot for me to get at it. I'll have to take a look this weekend. Seeing if anyone else had this issue.

[Bowline]

I had the same problem - the drain tube from the fridge drain tray had a kink in it and plugged it up. I found the tube was too long, so I just cut off a little and straightened it out. No more kink. That fixed it.

[JRTJH]

Same with ours. I think the factory "installer" ties the drain hose around a part of the ammonia tubing. Ours was actually tied around the cooling tube. I was able to reach up inside (using a flashlight and mirror) and get it untied, then just pulled it all down until it was "almost tight" and ran it through a slot in the access door. I also cut off the extra and reinstalled the drain "stopper" which has 3 holes in it.

In fact, in the owner's manual/installation instructions, it says to make sure the hose does not have any kinks or twists in it. LOL Hmmmmm, I wonder why the guys at the factory do it that way?????

[DTJ9610]

I finally had a chance to look at it over the weekend and did get it straightened out. Hopefully that should take of that.. One item down, a few more to go...