|
07-19-2022, 05:26 PM
|
#1
|
Junior Member
Join Date: Aug 2021
Location: Malta
Posts: 11
|
Fuzion 430 generator problems
We have 2022 Fuzion 430 and the generator will not stay running more than 30 minutes or less. Has a 36 code, changed oil and filter so oil level is correct. Once it shuts down and try a restart no luck unless you push the primer button then it runs maybe 10 minutes. Do these have an additional fuel pump back at the tank? How about a fuel filter? My other Onan has a filter at the carb don't see one here. Does the fuel station have to be on? The hour meter shows 994 hours on a brand new unit, really starting to piss me off.
Thanks Rick
|
|
|
07-19-2022, 05:37 PM
|
#2
|
Site Team
Join Date: Jul 2014
Location: Modesto
Posts: 20,337
|
Since a 36 code can be related to fuel pressure, there should be a fuel filter located where the rubber line enters the gen. There isn’t another pump at the tank that I’m aware of and you don’t need to have the fuel station turned on. There may be a restriction in the line, maybe some junk in the tank clogging the pick up.
You might want to get a can of fuel, run a fuel line to the gen and see if it runs. That will tell you if the issue is the gen or the fuel supply.
__________________
2012 Copper Canyon 273FWRET being towed by a 1994 Ford F350 CC,LB,Dually diesel.
Airlift 5000 bags, Prodigy brake control, 5 gauges on the pillar.Used to tow a '97 Jayco 323RKS.
Now an RVIA registered tech. Retired from Law enforcement in 2008 after 25+ yrs.
|
|
|
07-19-2022, 07:22 PM
|
#3
|
Senior Member
Join Date: Jul 2013
Location: Box Elder
Posts: 2,908
|
The 994 hours are probably just break-in running time
__________________
Bob & Becky
2012 3402 Montana
2012 Chevy 2500HD D/A CC
|
|
|
07-19-2022, 08:14 PM
|
#4
|
Senior Member
Join Date: Mar 2014
Location: Las Cruces
Posts: 4,665
|
I’ve seen a partially linked fuel line coming from the tank cause similar problems. Sounds like a slow fuel pick up. Once it sits for a bit, the vacuum on the line pulls fuel into the line, but once it starts up and uses that fuel, it can’t draw more fast enough. I’d trace the fuel line back and make sure it isn’t kinked somewhere.
|
|
|
07-21-2022, 04:54 PM
|
#5
|
Junior Member
Join Date: Aug 2021
Location: Malta
Posts: 11
|
So this is what i discovered. A nearly total kink just about 12" before going up to the fuel pump. Looks like the installer had pulled the slack up to the generator and pulled a little to hard. Had good flow of fuel out of the hose. One more problem, now no gas is getting into the carb. Pulled the carb, couldn't blow any air into the bowl. Removed the bowl and needle still no flow. found a little red fleck stuck in the seat. Not sure what it could have been. Reassemble and it ran for 1 1/2 hours before I shut it down.
Made me a happy camper!
Thanks for all the help
|
|
|
07-21-2022, 05:13 PM
|
#6
|
Site Team
Join Date: Jul 2014
Location: Modesto
Posts: 20,337
|
Glad to hear you got it.
__________________
2012 Copper Canyon 273FWRET being towed by a 1994 Ford F350 CC,LB,Dually diesel.
Airlift 5000 bags, Prodigy brake control, 5 gauges on the pillar.Used to tow a '97 Jayco 323RKS.
Now an RVIA registered tech. Retired from Law enforcement in 2008 after 25+ yrs.
|
|
|
07-22-2022, 06:49 AM
|
#7
|
Site Team
Join Date: Mar 2011
Location: Gaylord
Posts: 26,995
|
Just curious abot that "new generator with 994 hours on the meter"...
After your 1.5 hour run, what did the hour meter read ???
__________________
John
2015 F250 6.7l 4x4
2014 Cougar X Lite 27RKS
|
|
|
07-22-2022, 12:10 PM
|
#8
|
Senior Member
Join Date: Mar 2014
Location: Las Cruces
Posts: 4,665
|
With the symptoms you described, I figured it was a kinked fuel line. Glad you got it taken care of.
I’m also kinda curious about the 994 hours. Keystone doesn’t ship them with fuel, the dealer has to service them and make sure everything is running. Doesn’t sound like your service department did much since the fuel line was kinked. Don’t know how it would have gotten almost 1,000 hours on it. Even 99.4 or almost 100 hours would be excessive for a dealer service. That’s normally 1-2 hours. I’m wondering if the meter is bad or if you got some type of a refurbished unit.
|
|
|
07-25-2022, 08:26 PM
|
#9
|
Junior Member
Join Date: Dec 2021
Location: Tracy
Posts: 18
|
From the factory mine showed 3 or 4 hours on it. I knew the selling dealer did not run or test it as the generator was not even hooked up to the batteries and I had to trouble shoot for them why it wouldn’t start. Go figure. I looked through the in command book and found how to reset the hour meter.
|
|
|
08-02-2022, 05:46 PM
|
#10
|
Junior Member
Join Date: Aug 2021
Location: Malta
Posts: 11
|
Not sure how the 994 hours got on it. It's sure looks like a brand new unit that's for sure. QC sure has taken a dive. aktmracer where did you find the reset info?
Thanks Rick
|
|
|
08-02-2022, 08:30 PM
|
#11
|
Junior Member
Join Date: Dec 2021
Location: Tracy
Posts: 18
|
Quote:
Originally Posted by RStarkey
Not sure how the 994 hours got on it. It's sure looks like a brand new unit that's for sure. QC sure has taken a dive. aktmracer where did you find the reset info?
Thanks Rick
|
If memory serves, I called In-Comand and they walked me through it providing a code that needs entered. I’m pretty sure I wrote down the process in my manual. I can take a look tomorrow night when I get home and get back to you.
__________________
2022 F-350 DRW Lariat 6.7, SPE&Banks upgrades, Stryker leveling kit, DDC Wheels, 295/55-22 Nitto’s, BMC/Rigid Industries lighting, Mag Hytec engine pan, AirLift 5000’s
2022 Fuzion 373
2020 Road Glide- Scorched Orange
KTM’s…
|
|
|
08-06-2022, 05:42 PM
|
#12
|
Junior Member
Join Date: Dec 2021
Location: Tracy
Posts: 18
|
Quote:
Originally Posted by RStarkey
Not sure how the 994 hours got on it. It's sure looks like a brand new unit that's for sure. QC sure has taken a dive. aktmracer where did you find the reset info?
Thanks Rick
|
Here you go…Sorry for the delay
__________________
2022 F-350 DRW Lariat 6.7, SPE&Banks upgrades, Stryker leveling kit, DDC Wheels, 295/55-22 Nitto’s, BMC/Rigid Industries lighting, Mag Hytec engine pan, AirLift 5000’s
2022 Fuzion 373
2020 Road Glide- Scorched Orange
KTM’s…
|
|
|
08-07-2022, 05:24 PM
|
#13
|
Junior Member
Join Date: Aug 2021
Location: Malta
Posts: 11
|
Do you happen to have the code?
Thanks Rick
|
|
|
08-07-2022, 05:44 PM
|
#14
|
Junior Member
Join Date: Dec 2021
Location: Tracy
Posts: 18
|
I sent you a DM
__________________
2022 F-350 DRW Lariat 6.7, SPE&Banks upgrades, Stryker leveling kit, DDC Wheels, 295/55-22 Nitto’s, BMC/Rigid Industries lighting, Mag Hytec engine pan, AirLift 5000’s
2022 Fuzion 373
2020 Road Glide- Scorched Orange
KTM’s…
|
|
|
08-08-2022, 09:57 AM
|
#15
|
Junior Member
Join Date: Feb 2022
Location: Bozeman
Posts: 4
|
I don't remember the code but i remember it didn't match my problems that i was having. I just happened to find that the coil wasn't working by accident.Pull the spark plug out of each cylinder and see if each cylinder is firing. Hope this helps.
|
|
|
08-08-2022, 10:40 AM
|
#16
|
Senior Member
Join Date: Jun 2022
Location: Floresville
Posts: 106
|
Quote:
Originally Posted by kopcar
I don't remember the code but i remember it didn't match my problems that i was having. I just happened to find that the coil wasn't working by accident.Pull the spark plug out of each cylinder and see if each cylinder is firing. Hope this helps.
|
This Item works great...
https://www.harborfreight.com/in-lin...ker-63590.html
__________________
2019 Laredo 325RL
2017 Ford F350 DRW
USAF Retired, (20 years, Firefighter)
|
|
|
08-09-2022, 05:55 PM
|
#17
|
Junior Member
Join Date: Aug 2021
Location: Malta
Posts: 11
|
Quote:
Originally Posted by aktmracer
Here you go…Sorry for the delay
|
Got the info, reset and we now have a whole lot newer generator
Thanks again
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|