Slide out bottom seal ...
The bottom seal on my slide is a co-extrusion (bottom leg and "D" shaped slide wear bar are plastic and the top leg is the rubber wipe): http://www.trekwood.com/products/446...-Black-12-1-2-
Over the years the rubber wipe progressively tore, so like roadglide, this season I cut off the rubber wipe and rounded the edge where the rubber was cut at. I then used a 1/16" thick by 2 1/4" wide strip of neoprene held by a 1/8" x 1" wide aluminum strip to recreate the rubber wipe. The wipe action is now not prone to tearing the neoprene wipe because it forms a larger bend and there is more clearance under the slide. But if it does tear again, it is easy to replace in the future.
__________________
2018 Jayco Eagle HT 265BHS (previous: 2015 23RB Passport Elite, ProPride)
2015 F250 XLT SB Crew, 6.2l gas
PullRite 16K SuperGlide w/SuperRail
Reese 5th Airborne (bagged) Pin Box
RoadMaster Shock Kit
X-Factor Cross Bracing
|