|
11-23-2020, 04:17 PM
|
#1
|
Senior Member
Join Date: Aug 2020
Location: Upper Chesapeake Bay
Posts: 4,833
|
Anode rod
I’ve used my fifth wheel for 5 trips since august .... I drained my water heater for the winter and was surprised at how much the anode rod deteriorated. I will post a picture tomorrow but it was noticeably worn away in one area. My unit was built in DEC of 2019 but I bought it new in august. I have a ems and everything looks good and works good. Is that normal for rvs? I don’t have that problem on my boats.
__________________
2020 Cougar 315 RLS
2020 Ram 3500 6.7HO 4.10 Dually Aisin
|
|
|
11-23-2020, 04:20 PM
|
#2
|
Senior Member
Join Date: Nov 2017
Location: Mico, TX
Posts: 7,461
|
Quote:
Originally Posted by bjasin1
I’ve used my fifth wheel for 5 trips since august .... I drained my water heater for the winter and was surprised at how much the anode rod deteriorated. I will post a picture tomorrow but it was noticeably worn away in one area. My unit was built in DEC of 2019 but I bought it new in august. I have a ems and everything looks good and works good. Is that normal for rvs? I don’t have that problem on my boats.
|
Anode rods are a product of their watery environment. One will last a couple seasons and another will need changing in 6 months. Depends on the water. The minerals in the water attack the rod and that is the rod's function. Somewhere with soft water will last longer than real hard. They are only a couple bucks so just change it out; doesn't matter if you have an EMS and everything is great otherwise. The rod's deterioration is its purpose.
__________________
wiredgeorge Mico TX
2006 F350 CC 4WD 6.0L
2002 Keystone Cougar 278
2006 GL1800 Roadsmith Trike
|
|
|
11-23-2020, 04:24 PM
|
#3
|
Senior Member
Join Date: Aug 2020
Location: Upper Chesapeake Bay
Posts: 4,833
|
Quote:
Originally Posted by wiredgeorge
Anode rods are a product of their watery environment. One will last a couple seasons and another will need changing in 6 months. Depends on the water. The minerals in the water attack the rod and that is the rod's function. Somewhere with soft water will last longer than real hard. They are only a couple bucks so just change it out; doesn't matter if you have an EMS and everything is great otherwise. The rod's deterioration is its purpose.
|
Ok I understand. I know with my boats if I have an anode wearing quickly it can mean that I have stray electric current Of course I’m talking about my below water anodes on my prop shafts and rudders And yes I’m going to replace I just thought it was odd to deteriorate that quickly but I didn’t think about water quality so that makes sense
__________________
2020 Cougar 315 RLS
2020 Ram 3500 6.7HO 4.10 Dually Aisin
|
|
|
11-24-2020, 07:05 AM
|
#4
|
Senior Member
Join Date: Aug 2013
Location: Tucson
Posts: 822
|
Quote:
Originally Posted by bjasin1
Ok I understand. I know with my boats if I have an anode wearing quickly it can mean that I have stray electric current Of course I’m talking about my below water anodes on my prop shafts and rudders And yes I’m going to replace I just thought it was odd to deteriorate that quickly but I didn’t think about water quality so that makes sense
|
It's a "sacrificial anode" and uses galvanic current between two different metals (on the electromotive series) to force the sacrificial metal (anode) to corrode and protect the other metal (cathode). You are right about stray current being a potential problem on a boat where the electrolyte (water) is outside the boat and in contact with the boat hull, the anodes, and anything else electrical and in the vicinity. In your RV, however, the electrolyte (water) is contained within the tank and in contact with the anode. There can't be any stray current inside the tank.
|
|
|
11-24-2020, 07:42 AM
|
#5
|
Senior Member
Join Date: Aug 2020
Location: Upper Chesapeake Bay
Posts: 4,833
|
Quote:
Originally Posted by LewisB
It's a "sacrificial anode" and uses galvanic current between two different metals (on the electromotive series) to force the sacrificial metal (anode) to corrode and protect the other metal (cathode). You are right about stray current being a potential problem on a boat where the electrolyte (water) is outside the boat and in contact with the boat hull, the anodes, and anything else electrical and in the vicinity. In your RV, however, the electrolyte (water) is contained within the tank and in contact with the anode. There can't be any stray current inside the tank.
|
Yes I understand how they work I was just pondering how an rv electrical system works. Wasn’t sure f the breaker panel in rv would fall under the neutral bonding rules of sub panels in homes I know the ems protects me from incoming power from the pedestal but not sure if it recognizes bad grounding and bonding issues inside tv from factory. I know they had a inverter wire recall on some models and not sure if ems would recognize any problems with that as an example. Although mine does not have that recall I’m just wondering how the ground and neutral system is bonded so electric is not finding its way back through ground and casing of water heater to its source
|
|
|
11-24-2020, 08:00 AM
|
#6
|
Senior Member
Join Date: Aug 2013
Location: Tucson
Posts: 822
|
Quote:
Originally Posted by bjasin1
Yes I understand how they work I was just pondering how an rv electrical system works. Wasn’t sure f the breaker panel in rv would fall under the neutral bonding rules of sub panels in homes I know the ems protects me from incoming power from the pedestal but not sure if it recognizes bad grounding and bonding issues inside tv from factory. I know they had a inverter wire recall on some models and not sure if ems would recognize any problems with that as an example. Although mine does not have that recall I’m just wondering how the ground and neutral system is bonded so electric is not finding its way back through ground and casing of water heater to its source
|
Right; I don't believe your EMS will provide any protection on the RV side from bonding/grounding issues. However, even if you had a floating ground through the water heater, any current passing through the outside of the steel tank would not have any impact on the inside of the steal tank.
|
|
|
11-24-2020, 08:11 AM
|
#7
|
Senior Member
Join Date: Aug 2020
Location: Upper Chesapeake Bay
Posts: 4,833
|
Quote:
Originally Posted by LewisB
Right; I don't believe your EMS will provide any protection on the RV side from bonding/grounding issues. However, even if you had a floating ground through the water heater, any current passing through the outside of the steel tank would not have any impact on the inside of the steal tank.
|
Ok thanks I’m gonna look at all my grounds while I’m thinking about it just for the sake of it
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
All times are GMT -8. The time now is 04:04 AM.