Need help finding aluminum molding track that seals the cap on a 2012 Raptor 300MP.

[ToyTLH]

I had something propped up to high in the front right corner of the box in my truck while pulling my 2012 Raptor 300MP and while making a sharp right turn, it must have snagged the plastic molding/aluminum track that covers the junction point of the front cap to the main trailer’s outside panels

I've searched many RV molding and trim sites/online catalogs and I do not see this gull wing profile for the aluminum track that screws into the joint area and then you snap the soft molding on to it.

It makes me sick – my Raptor is like brand new and I store it inside so there is no weather/sun fade/damage. At least it is hid underneath but I know it is there!

With a Dremel tool, I can cut out the bad section and splice in a new section if I can just find the replacement items.

Should I call Keystone?

Thanks for the help and the great forum

[Festus2]

ToyTLH -

The forum has a sticky "RV Suppliers & RV Parts Sources" which can be found in the Repairs & Maintenance Section. It's up at the top of the thread list.

You might browse through these suppliers and sources to see if you can find what you are looking for.

[JRTJH]

You might also consider contacting your dealer's service parts department. I'd almost bet they have it in stock in 8" sections.