Hornet 31 RBDS Slideout

[c_spingola]

Next questions. 2010 Hornet 31 RBDS Last few trips out with the TT the slides were real stubborn about coming back in. I had to crawl under to the pump and wiggle the wires for it to work. I cleaned all of the connections and applied dielectric grease and it seemed to work. This past trip they would not move back in at all. I had to use a Hex wrench on the override side to start cranking them in by hand then once in about a 1/4 of the way in I clicked the slide button again and they came in. Any advice?

[Ken / Claudia]

First off your battery must be fully charged even if when hooked up to shore power(thats when my slide says above the control panel) same as last RV I had. Sounds like could be a loose wire if moving them made the slide move. Look for chewed/loose wires. The track should have a dry lube on it and no rust.