The video doesn’t reflect the seals your have on your Alpine slide out.. the slides all use a channel seal held in position by 1 screw on each end..
Simply remove the two screws on each vertical wiper seal and the two screws on the horizontal wiper seal for the slide out roof
Remove one seal at a time... use old seal to measure the new seal length and mark where the two new holes need to be to reinstall in new wiper seal when in place.
Cut the new seal to length and on the vertical wiper seals start working it into channel from the top and work down.. takes about 2 minutes. Reinstall the previously removed screws
I used my wife’s large pair of kitchen scissors to cut thru the light metal that’s in the edging of the seal lip...
Do the same for the other vertical wiper seal and then finish up with the horizontal wiper seal
I simply laid on the roof and with slide out open removed those tw9 screws and worked old seal out and new one in...3 minute job
The seal is 018-546 2 inch wide clip on.. Amazon had the best price at the time I replaced mine...
No adhesive is used anywhere when replacing the wiper seals on the 3010.. there is nothing to clean before installing new wiper seals. Just remove, install and put the screws back in place.
The roll is 35 feet in length and will easily do one complete large side out. I only replaced the top wiper on one slide and verticals on another slide due to cracking.
My RV is a 2014 Alpine 3010RE
Trekwood also has the wiper seal but you will pay a ton more in shipping.
https://www.trekwood.com/products/29...lip-On-1225-Bx
These folks also have the seal you need and are great to work with...
https://www.camperid.com/ap-products...n-018-546.html
Linear Mode
