Quote:
Originally Posted by mikec557
|
So here is my current start of my setup for Solar and Inverter. As you can see, I'm using some or most of the ideas from this thread to get my install started. I still need to purchase the SCC, some 8ga wire, 6ga wire, and another 30amp breaker. The inverter is a auto switch over at 1200 watts.
I also want to note that my camper came with a residential fridge that is already connected to an inverter somewhere in the camper. It's on a 20amp breaker in the fuse panel and the light inside the fridge is on when disconnected from Shore Power. I know it drains the battery when at my last outing the camp site at Stone Mountain in Atlanta lost power due to a transformer going out. The camp host told me the power outage was due to a couple of geese. Not sure if they lived.
Anyway, I only had the stock 65amp/hr battery at the time and had to shut down everything during the outage to keep the heat going (it was about 32 degrees the two weeks I was out there) and the fridge. That's when I decided to get two 100 amp/hr batteries and are now wired in parallel.
Have any of you actually taken the wood panel off from the basement that conceals all of the wiring behind it? Is it a pain in butt?
I would rather route power out to the battery from the basement without having to cut holes in my basement floor. Maybe if I took off the wood panel, I could figure out where the rest of the wiring goes out to the tongue.
The last picture is my plan...
Threaded Mode
