Quote:
Originally Posted by chuckster57
Try spraying some dry lube on the bolt and operating it a few times. I have adjusted strike plates on too many units to count, and spraying the dry lube makes it even easier
|
We have a2018 Alpine 3501rl with a lipert component LCI solid Step that requires slamming to close the door. Also when closed we can see daylight at the lower right corner (while in the tt). It almost appears that the door is bent but when open the door appears normal. Other than taking a large hammer to make the floor plate go down is there another way to fix this. I thought about shortening the adjustable step so perhaps after stepping on the stairs several times it may make the step plate lower so the door can close properly. Any ideas?