Keystone RV Forums - View Single Post - 31SQB top flip-up bunk pulling out of wall

Hercules1978 · 07-29-2014, 09:10 PM

I have a 2 month old 31SQB that we noticed the top flip-up bunk was sagging. The stickers on the walls say 300# limit. My son's are 120# and 220#. On our last trip my oldest used this top bunk.

Unless my math is wrong, he should have been under the weight limit.

Here's a pic of the middle hinge of 3. I attempted to tighten these today and they are stripped inside the wall and will not tighten. The screws on the other 2 hinges are tight, however, and appear to only be attached to the paneling. I can pull the whole bunk out from the rear wall and watch the paneling move.

I have instructed everyone to not use this bunk for anything but holding clothes while changing.

Please check your bunk attachment points.

07-29-2014, 09:10 PM	#1
Hercules1978 Member Join Date: Mar 2014 Location: Fraser, Michigan Posts: 93	31SQB top flip-up bunk pulling out of wall I have a 2 month old 31SQB that we noticed the top flip-up bunk was sagging. The stickers on the walls say 300# limit. My son's are 120# and 220#. On our last trip my oldest used this top bunk. Unless my math is wrong, he should have been under the weight limit. Here's a pic of the middle hinge of 3. I attempted to tighten these today and they are stripped inside the wall and will not tighten. The screws on the other 2 hinges are tight, however, and appear to only be attached to the paneling. I can pull the whole bunk out from the rear wall and watch the paneling move. I have instructed everyone to not use this bunk for anything but holding clothes while changing. Please check your bunk attachment points.