[Keystoned]

Good news...got it all done. Bad news...there were a couple of small spots where I saw some wood. So either there was a hole in the TPO there or they came up just short of enough TPO. Either way, the wood looked normal and not rotted so I made sure there was extra dicor on that area with no clear water path.
The other corner also had a huge gap to be filled and there were a few places along the top where there were gaps also. I would call these factory defects...it may have leaked from day one.
The rubber cover that goes over the metal strip and screws does not look salvageable. Any ideas where to get new stuff?
The butyl tape under the metal strip was only about an inch wide, btw.