Quote:
Originally Posted by ChuckS
That slide out should be Hyd.. during its initial motion coming in the slide floor rides up and onto a wear bar that is underneath the slide ... the Darco material slides across this as slide comes 8n and last few inches as it fully closes slide levels out..
You might want to retract that slide about 4 inches or so and then use a sock and talcum powder and reach around the back edge of slide inside and wipe that interior seal...
This could be causing the top to stick and hang up...
Also do not ever use any so called slide seal conditioner. You want a sticking slide and torn seals...this will sure cause that to occur
If this doesn’t correct issue then either vertical height of slide is not adjusted correctly and/or one or both hyd gear packs has an issue and is binding
|
Be careful with the talcum power... the OP (Larry) might get ovarian cancer and be eligible for a huge payment via class action... saw it on the TV!
