Quote:
Originally Posted by Logan X
I screwed a piece of pressure treated lumber to the battery tray using the existing holes from the old battery box. Then I used general purpose screws to screw through the bottom of the battery box and the bottom of the shunt box into the piece of lumber. I’ve used that set up for several years with no issue.
Here is the dual 6v battery box
https://www.amazon.com/NOCO-HM426-Co.../dp/B003VAUG5A
And here is the shunt box
https://www.amazon.com/SOCKiTBOX-Wea.../dp/B009RX5GI2
I know I posted some of this stuff in the other thread you posted on, but I wanted to post it here too for future viewers.
I included a picture of how the lumber is attached. That photo is taken from under the tongue.
|
Thanks Logan. Seeing pictures of the different methods that others have done is very helpful.