[ChuckS]

Even the latest In Command version “Global Connect” version NSCP3 and NSCP35 owners are having issues.
Issues seen are ..
1. HVAC temp for a zone reads -F degrees
2. Issues with the slide outs showing “Short..system disabled”
3. Loss of control to one or more HVAC zones
4. Travel lockout enabled ( when no truck is connected to 7 way plug
5. Loss of control of one or more interior lighting zones
6. Water heater issues with turning on

These are being reported by Alpine and Montana owners

One could either build their own manual panel with switches and labels and then find a way to drag each set of feed wires from the existing BCM connections OR..

There are several decent multi switch wireless switch panels available .. the wires could be removed from BCM and attached to the wireless relays and mount those switches onto a nice panel of sorts.

The remote wireless switches are pretty reliable and would be easier to handle then trying to draw every wire from the BCM back inside to a central location for a full switch panel

There of course would be more cost for the wireless switches but it is a thought to ponder over