|
Next chapter, I got home and got out my drill and found where the manual bolt was to unwind my awning. I ran it out a little ways and then checked to see if the retract switch would work. It didn't, blew the fuse. Then I tried the extend switch and it worked, but because the awning was rolled the wrong way, it actually retracted it instead. I had to use my drill and extend it all the way out and then roll it up with the awning rolled on top instead of the bottom. Currently my awning is retracted and rolled in the correct way. The extend switch works to extend but the retract switch blows fuse. Before pushing the retract switch, I run the awning out a little with the extend switch. The motor seems to be working. Any explanation why the pushing the retract switch causes the fuse to blow. I hope I explained the problem correctly.
|