|
If it’s cable driven then the motor is above the slide, inside centered. You should have received a flexible shaft with a squarehead driver on the end. The driver end goes into the gearbox at the motor and the hex drive goes into a drill chuck. Operating drill will operate gear box and extend/retract slide. On some models you have to remove the upper slide Facia to access the motor/gearbox.
__________________
2012 Copper Canyon 273FWRET being towed by a 1994 Ford F350 CC,LB,Dually diesel.
Airlift 5000 bags, Prodigy brake control, 5 gauges on the pillar.Used to tow a '97 Jayco 323RKS.
Now an RVIA registered tech. Retired from Law enforcement in 2008 after 25+ yrs.
|