View Single Post
Old 03-26-2020, 08:19 AM   #17
travelin texans
Senior Member
 
travelin texans's Avatar
 
Join Date: Nov 2017
Location: Picacho, Az
Posts: 6,809
Quote:
Originally Posted by JRTJH View Post
Yes (and no)…

If you wrap Teflon tape around the threads, insert the anode and tighten it "slightly" then immediately remove it and inspect the threads, you'll find that the threads "cut the Teflon tape" to make "some slight electrical (metal to metal) contact, so even with Teflon tape, there is "conductivity" between the two pieces. Add the water that sits "at the edge of the threads inside the tank" and you've got significantly more "electrical conductivity" than the very slight "pico-volts" required for anode/cathode conductivity".....

When you consider that the end of the threaded anode nut and the threads on the water heater tank will make contact (via the water in the tank) there is no "effective means to insulate them, no matter how much Teflon tape is wrapped around the threads. Add the "physical cutting of Teflon" that also occurs when the threads mesh and tighten, it's "impossible not to have conductivity".....

Not to mention without the Teflon tape you'll likely not get the rod removed the next time without damaging the tank, if at all
__________________
Full-timed 10+ years
Sold '13 Redwood FB
Traded '13 GMC Denali DRW D/A
Replacement undetermined
travelin texans is offline   Reply With Quote