[ChuckS]

I can assure you that the time has not a ting to do with the In Command crashing issue..

What IS CAUSING the issue is a GLITCH IN VOLTAGE along the 12 volt DC BUS that also feeds the BCM and In Command display.. This will immediately cause the BCM to falter and the display to falter as well

Either the OP has a bad battery ( even though on shore power ), loose or dirty battery cables, loose 12 vdc pwr feed to BCM or loose ground to BCM..

If the issue only occurs when slides or some other heavy current draw item is operated then a loose, corroded, connection on that specific item can also cause glitch on the main DC BUS..

Also a weak resettable DC breaker for a slide out will cause intermittent amperage draw and cause same issue