Most if not all devices containing motors, compressors, and electronics do not like to operate in an environment where the source power is constantly going on and off. Obviously when power is lost the device goes off. A cheap design to incorporate on the power up cycle would be to add a time delay between when the first time power is sensed till it is considered to be stable (no on/off). At this time power is applied to the device. A longer delay basically provides more insurance that the power is stable before being applied to the device, however it does further delay the device operation.
__________________
2013 RAPTOR 300MP w/Rear Patio Deck NO Folding Side Ladder
2013 Silverado 3500HD LTZ CC LB 4X4 DRW
Duramax 6.6L Turbo Diesel; Allison Trans
Reese 20K; Carlisle Radial Trail RH/HD; TPMS (12 Tires)
Veteran
PSU (GO LIONS)
|