.
Yesterday I was flushing the plumbing including the fresh water tank on my 2016 Bullet 1800RB. They have a useless stub out that is 5" below the tank. You have to crawl under the TT to unscrew the plastic cap to drain the freshwater tank.
So today I scrounged up some plumbing supplies I had kicking around and got rid of that mess on the bottom of the tank and installed a 3/4' ball valve that I can reach without crawling under the trailer. I am happy with the result.
I attached a 5" x 10" x 1 ½" board to the trailer rail using two carriage bolts.
The ball valve assembly is attached to the board with Tridon Clamps.
Shows the 3/4" PEX attached to the water tank.
Shows 90 degree ½" MIP by 3/4" PEX fitting screwed into the tank. This fitting only hangs down 1 ½".
Shows male garden hose connection with brass safety cap screwed to it.
.
__________________
2016 Bullet 1800RB, UVW 3260, led by a 2005 Chev Silverado Z-71 1500, Crew Cab, 5.3L, 4WD, Tow & Off Road Package with 4.10 Rear Axle, GVR 7000 lbs, Front GWAR 3925 lbs & Rear GWAR 4000 lbs., Payload 1600 lbs., Hellwig 6012 Air Bags. 97' Honda Goldwing GL1500.
Home Base is the Alberta Foothills at 4300 ' ASL.
