Quote:
Originally Posted by IrishPatNJ
Hoping I can save some others the struggles i faced. See the picture of the final product. The view is from the front of the rig looking back.
- Cut the 3" pipe in the two locations where you see my rubber couplings in the picture.
Good luck! |
Just me personally, I'd try to only cut the 1.5" - 2" section where the rubber coupling is on the right side and then disconnect both valves on the left of that (from your pic perspective.) That way, you'd only have one rubber coupling (just one coupling for possible/probable future leak) but this is just my opinion and wish I had seen this before trying to 'man-handle' mine out of the rigid section! I had to patch my tank at the outlet due to the stress of tweaking/twisting to get the valve out. And it's started leaking again, so I'm going to have to replace my black tank!