Quote:
Originally Posted by zinger290kb
i have the yellow cable and i want to install a renogy 2000 watt inverter with pure sine wave tech on it. From reading this form i understand i have to cut it the yellow wire to connect the hot on my inverter but i only have and out put for the wires on my inverter. Do i connect all wires to the port?
|
Welcome to the forum
Your inverter should have 3 sets of inputs/outputs.
AC in
AC out
DC in
Your yellow Romex is a loop. You need to cut it with the power OFF. Then determine which side is HOT when plugged into shore/generator. That Romex goes to AC IN. The other side goes to AC out.
DC in is for the leads coming from the battery(s).
Does your inverter have “pass through”? If not you’ll need to wire it differently with a transfer switch.
__________________
2012 Copper Canyon 273FWRET being towed by a 1994 Ford F350 CC,LB,Dually diesel.
Airlift 5000 bags, Prodigy brake control, 5 gauges on the pillar.Used to tow a '97 Jayco 323RKS.
Now an RVIA registered tech. Retired from Law enforcement in 2008 after 25+ yrs.