Keystone RV Forums - View Single Post

Tracker · 03-22-2020, 10:14 AM

Went to put new plate tags on last week and found the lower left rear cap separating from the side wall. Noticed last fall after the last trip that the bottom of rear cap felt loose when removing the power cord. Was going to see if if I could add a piece of angle iron to secure it. Do not see any damage on the inside rear wall. Also have not run in to anything. The trailer is a 2014 Mountaineer 331rl. What can I do to secure this?

03-22-2020, 10:14 AM	#1
Tracker Junior Member Join Date: Oct 2014 Location: Thornton CO Posts: 7	Rear cap coming loose Went to put new plate tags on last week and found the lower left rear cap separating from the side wall. Noticed last fall after the last trip that the bottom of rear cap felt loose when removing the power cord. Was going to see if if I could add a piece of angle iron to secure it. Do not see any damage on the inside rear wall. Also have not run in to anything. The trailer is a 2014 Mountaineer 331rl. What can I do to secure this? Attached Thumbnails