Quote:
Originally Posted by Neo1130
Bring a chunk with you. Just because the measurements are close doesn't always mean it will work. The stiffness and whatnot should match as well. If the new stuff is TOO hard, it may not allow the window to close, but it'd be worth a shot. And again, clean as MUCH of that old silicone off as possible. Any residue left behind will prevent the new stuff from sticking. Silicone is the devil...
|
Already have a piece cut and in the car to go with me tomorrow. The window frame actually doesn’t have any silicone on the section that the seal stick to , but I spent yesterday evening scrubbing inside and outside of the outer frame area so all good there.