Quote:
Originally Posted by mstat
"Reversing registers"
As delivered furnace duct work ran from furnace on street side, over to curb side, down the length of the trailer, then back towards the street side and registers. Air came in from curb side towards street side
What technician did was to pull the register out, and reversed them so that a shorter piece of duct work was used.
Now air comes from furnace and basically goes down middle of trailer to register then a short bend towards the curb side into the register. On the one run he probability pulled 10 feet of duct work out.
Was easy to build in factory but not so good on the heat.
|
I wonder how many trailers are built this way with too much duct work just because it was easy? The consumer feels it in the winter with the inefficient runs....