Thread: Floor heat
View Single Post
Old 01-21-2018, 05:54 AM   #11
rhagfo
Senior Member
 
rhagfo's Avatar
 
Join Date: Apr 2012
Location: Portland, OR
Posts: 4,161
Quote:
Originally Posted by Frisbeekev View Post
It's a brand new camper. Worked before. Will check the lines, then get it to the dealer if needed. Thanks
if it worked before, then likely something new is either blocking the duct, or if flexible ducting it may have come disconnect or crushed.

I would check the connections at the furnace first, if you have rigid in floor duct I would make the seal between the duct and furnace better, factories tend to just set the furnace over the hole in the floor! That creates a very poor seal! This is when a roll of good foil duct tape is your best friend. I used to seal all unused covers on our furnace, and all floor connections.

Quote:
Originally Posted by IRV2 View Post
This is what we discovered when we pulled out the register on our new 5th wheel.
This looks like loading damage, seeing the carpet in the picture looks like a 5er basement. To me looks like somebody shoved something in to the space and knocked the register box loose and tore it duct. Might think about devising protection for that register box!
__________________
Russ & Paula and Belle the Beagle.
2016 Ram Laramie 3500 DRW 14,000# GVWR (New TV)
2005 Copper Canyon 293 FWSLS 32’ GVWR 12,360
Visit and enjoy Oregon State Parks
rhagfo is offline   Reply With Quote