Quote:
Originally Posted by Johan
I have a Bullet 308BHS with the same soft spot, discovered today. The area that is soft is about4-5 ft wide and 1 to 1.25 ft deep when I stand looking into the front door.
I am leaving on vacation in 2 days, so I have to fix it myself.
I removed/cut the plastic liner/layer are removed the soggy pretend-wood, the polystyrene and the next layer of fake wood up to the vinyl flooring.
Going to put pressure treated wood in there for better support than the foam.
Fixing is not the problem, however, where did the water come in ??
It looks fine around the front door and front window, but the soft spot is centered around the rightmost side of the door, the side with the hinges.
Any tips on where I can apply extra sealant to not let this happen again ?
|
Hi,
I’m in the UK and purchased a Bullit from a company in the UK who export them over. I found an area on my one that would have let so much water in if I hadn’t found it. It was the front cap where it meets the roof. You need to check all this front cap especially where the LED lights go into the panel, my one had no sealant around the lights and a massive gap behind the light, if left this would have gone down behind the wardrobe and into the floor.
Thanks,
Mark