Quote:
Originally Posted by bill-e
Did you connects the panels to the trailer with the charge controller and the batteries connected? If the batteries were not connected the charge controller might act that way since it senses the battery voltage and applies the correct charging current depending on what it's reading from the batteries.
My Zamp panels wont actually put out anything until the batteries are connected, until then the controller shows an error message saying that there is no load.
|
Yes, I fid it both ways. The charge controller worked perfectly when attached directly to the batteries. I also tested the leads on rhe controller when not connected to the batteries and it still put out the correct power. It just doest work through the prewired connection in the trailer. There is a RV show on this weekend nearby. I'm going to ask there and hopefully get some answers. Keystone never got back to me.
Sent from my SM-G870W using Tapatalk