Quote:
Originally Posted by LHaven
Not to hijack this thread, though it already seems resolved...
My son has a more vintage MH with a TPO roof. He has two satellite dishes up top (there when he bought it) which don't work, and he'd just prefer to demount them and patch up the holes in the roof. What's the best way to go about this?
|
Remove them, place a 1/4 in sheet of plywood over the holes, right on top of everything. Use a few wood screws to hold it in place. Use a LOT of Dicor caulking under the plywood and around the screws, around the edges, seal it up good. Then cover the plywood with some new rubber roof material, enough to go over it all and extend beyond a couple inches. Use Dicor again around the edges and even Eternabond tape to hold the edges down on top of that. Done.
Before laying down the plywood, sand down the upper edge so its more rounded and not a sharp corner so it won't hurt the rubber roof material by cutting it.