[Snoking]

Originally Posted by WNY Bullet

I connected the truck, so there was no weight on the jack.
I disconnected power by removing the inline fuse to the jack.
I removed the two bolts from each side holding the motor head on.
Motor head lifted up and off the post.
There were two additional holes 90 degrees from the original ones used. They will need to be threaded (Tapped) to be able to accept the mounting screws.
Then screw the head back on in the new position.

So only the motor head is rotated, nothing else.

I hope that makes sense...

OK this is today's project if I have the right size tap. Will have to find the bag of taps I have first. When we downsize out of a home to two RV resorts, sometimes things are in the wrong state when you want to use them.

Thanks Chris