Quote:
Originally Posted by Snoking
So what was involved in turning the head 90 degrees? I want to do it. Thanks Chris
|
I connected the truck, so there was no weight on the jack.
I disconnected power by removing the inline fuse to the jack.
I removed the two bolts from each side holding the motor head on.
Motor head lifted up and off the post.
There were two additional holes 90 degrees from the original ones used. They will need to be threaded (Tapped) to be able to accept the mounting screws.
Then screw the head back on in the new position.
So only the motor head is rotated, nothing else.
I hope that makes sense...