View Single Post
Old 02-26-2020, 06:51 AM   #18
papachaz
Member
 
Join Date: Apr 2019
Location: Cedartown
Posts: 39
Quote:
Originally Posted by chuckster57 View Post
When you get the new controller, it will be straight forward to swap all the wiring harness’. Just don’t forget to put that little jumper back in.
I figure on taking it one wire at a time, off the old board, onto the new one. Not sure what jumper you're referring to, I do have a case number and am on a first name basis with a couple of the LCI Techs, so I know I can call and ask LOL

I also know I'll have to manually level it the reset the zero point, that's all pretty well spelled out in the manual and in a few videos I've watched, but I am curious about the jumper. When I first started working on computers, everything was set by jumpers or dip switches, so I'm very familiar so where is this jumper? in my looking at it, I don't remember seeing a jumper. I do have a pic so maybe I need to enlarge it and look at it
papachaz is offline   Reply With Quote