You didn't give any information about your rig;
- For emergency operation of our 3 cable actuated slide outs we use a normal cordless drill for operation of the overhead motors at each slide. For an alternative, we can also use the following procedure.
- For emergency operation of our hydraulic Level-Up system, I use the onboard generator and a 3/8" electric drill motor. My setup requires a 90" angle gear to reach the end of the motor, so I have two of those on hand. We do this because it takes thousands of revolutions (seems like, but probably a gross exaggeration) to move the rams very far and there are 6 rams.
- You should be able to find one of the newer 20V cordless devices that has the torque to turn the motor.