Seal is correct.
Dealer told us we needed to adjust our slide out, so we had it adjusted today.
Now, where the water was pooling is better, but there's still a gap between the rubber and the roof.
We ordered a slide cover, but technician recommended we either put a pole inside to push the top of the slide up, so rubber meets the roof.
Or, remove the facia and replace the header board inside.
Sounds like a mess.
ChuckS, would the wiper seal help us get the rubber to stick to the roof top, as it's supposed to?
"You can also shop around for TPE clip on wiper seal
https://elkrv.com/products/seal-wipe...et-tpe-clip-on"
Anybody have any other suggestions?
|