Forum: Keystone Questions
07-11-2021, 12:19 PM
|
Replies: 9
Views: 4,287
|
Forum: Toy Haulers
11-22-2017, 06:37 AM
|
Replies: 20
Views: 15,382
|
Forum: Toy Haulers
11-02-2017, 02:03 PM
|
Replies: 20
Views: 15,382
|
Forum: Toy Haulers
11-01-2017, 03:03 PM
|
Replies: 20
Views: 15,382
|
Forum: Toy Haulers
10-31-2017, 11:42 AM
|
Replies: 20
Views: 15,382
Good ideas Dave. I like the wet bolts...
Good ideas Dave. I like the wet bolts especially. And am not surprised on spring failure and figured they would be Chinese steel. American dreams built on bottom dollar imports.
Sent from my...
|
Forum: Toy Haulers
10-31-2017, 03:44 AM
|
Replies: 5
Views: 2,061
Did some more ops checking last night. Here's...
Did some more ops checking last night. Here's what I was finding:
1 of my Shortstop thermal breakers didn't have power going to AUX side (50A),
My generator kept showing overprime fault,
Only...
|
Forum: Toy Haulers
10-30-2017, 02:12 AM
|
Replies: 20
Views: 15,382
|
Forum: Toy Haulers
10-29-2017, 05:45 PM
|
Replies: 16
Views: 10,839
Mine were nice at first, but lasted about 10...
Mine were nice at first, but lasted about 10 seconds. They are cumbersome, awkward, pain in the arse in storing, so 9 out of 10 times we leave them at home. Also, because we have to close up each...
|
Forum: Toy Haulers
10-29-2017, 05:36 PM
|
Replies: 8
Views: 25,946
|
Forum: Toy Haulers
10-29-2017, 05:29 PM
|
Replies: 5
Views: 2,061
Bad charger?
So here's another dilemma to our new '16 Raptor 352TS. Last week, wife noticed fridge went to propane while on shore power (didn't share to me till after below problem). Then while fixing my broken...
|
Forum: Toy Haulers
10-29-2017, 05:12 PM
|
Replies: 20
Views: 15,382
Bad Leaf Spring?
2016 Raptor 352TS, owned for 11 months, 1 trip N.J. to S.D. and many trips into PA and started another trip and during walk around at normal snack stop before we hit the turnpike I noticed spacing...
|
Forum: Toy Haulers
05-30-2017, 05:56 AM
|
Replies: 3
Views: 9,535
Looks like the factory did the same to you on...
Looks like the factory did the same to you on fuel tank sending units, wires swapped. Mine was the same. Dealer can fix that. As far as BCM and functionality, I had the same issues. Have you...
|
Forum: Toy Haulers
05-28-2017, 11:10 AM
|
Replies: 6
Views: 6,522
|
Forum: Technical Corner
05-20-2017, 11:56 AM
|
Replies: 13
Views: 6,730
|
Forum: Technical Corner
05-19-2017, 03:11 PM
|
Replies: 6
Views: 2,072
So, came back to camper this evening, low and...
So, came back to camper this evening, low and behold it stopped communicating. Talked with Harold from ASA (company made Jensen InCommand) and it was Keystone decision to not put manual backup...
|
Forum: Keystone Questions
05-19-2017, 03:38 AM
|
Replies: 9
Views: 4,287
|
Forum: Technical Corner
05-19-2017, 03:35 AM
|
Replies: 6
Views: 2,072
I emailed the company asking about that and if...
I emailed the company asking about that and if they are planning on doing that. They gloriously replied for me to contact Keystone Raptor team about those switches.
Sent from my SAMSUNG-SM-T377A...
|
Forum: Technical Corner
05-19-2017, 03:33 AM
|
Replies: 6
Views: 2,072
|
Forum: Technical Corner
05-18-2017, 06:52 PM
|
Replies: 6
Views: 2,072
Incommand not working
I have an Incommand system in 2016 352TS that is not working properly and left me dead in water basically at 9pm upon setting up camp.
Powers on, touchscreen turns on, but no data is showing (gen...
|
Forum: New Member Check in!
05-16-2017, 07:13 AM
|
Replies: 21
Views: 4,435
|
Forum: New Member Check in!
05-16-2017, 05:29 AM
|
Replies: 21
Views: 4,435
|
Forum: New Member Check in!
05-16-2017, 04:42 AM
|
Replies: 21
Views: 4,435
|
Forum: New Member Check in!
05-16-2017, 04:02 AM
|
Replies: 21
Views: 4,435
|
Forum: New Member Check in!
05-16-2017, 03:56 AM
|
Replies: 21
Views: 4,435
|
Forum: Toy Haulers
04-23-2017, 07:36 AM
|
Replies: 18
Views: 8,563
I ran into similar situation of half of jack...
I ran into similar situation of half of jack system not lifting the bed. I found that the rod going across to other side fell out due to poor design if the hexagonal slide shaft that goes into...
|