Forum: Lite Weight Trailers
10-18-2022, 07:46 AM
|
Replies: 7
Views: 3,106
LOL - good point. I really only need 2.
I'd...
LOL - good point. I really only need 2.
I'd like to just get the cap as a matter of principle, but I may just bite the bullet (see what I did there?) and order a pair of new hub covers.
|
Forum: Lite Weight Trailers
10-18-2022, 06:46 AM
|
Replies: 7
Views: 3,106
Do you have a link to the one you purchased?
...
Do you have a link to the one you purchased?
I'm still trying to track down the correct part. Keystone sent me to Trekwood RV Parts who has center caps w/ inserts that will work but are not the...
|
Forum: Lite Weight Trailers
10-17-2022, 04:54 AM
|
Replies: 7
Views: 3,106
Bullet Center Cap
Does anyone know where to get a center cap for my Bullet? I went back and forth with Keystone, even sending them my serial number and a pic, but they ultimately sent me a part number for something...
|
Forum: Lite Weight Trailers
08-23-2022, 12:55 PM
|
Replies: 25
Views: 6,274
|
Forum: Lite Weight Trailers
08-23-2022, 11:18 AM
|
Replies: 25
Views: 6,274
|
Forum: Lite Weight Trailers
08-23-2022, 08:53 AM
|
Replies: 25
Views: 6,274
It's fractions of an inch. It will slide past...
It's fractions of an inch. It will slide past without much effort, but is starting to scrape up the lens. That's why I'm thinking if I can put enough pressure in that spot to move it up a bit, it...
|
Forum: Lite Weight Trailers
08-23-2022, 08:25 AM
|
Replies: 25
Views: 6,274
|
Forum: Lite Weight Trailers
08-23-2022, 08:04 AM
|
Replies: 25
Views: 6,274
|
Forum: Lite Weight Trailers
08-23-2022, 07:42 AM
|
Replies: 25
Views: 6,274
|
Forum: Lite Weight Trailers
08-23-2022, 07:25 AM
|
Replies: 25
Views: 6,274
I think the ceiling might be wood. "5 sides" of...
I think the ceiling might be wood. "5 sides" of aluminum is 4 walls and the floor. I had to replace the bathroom fan and I'm pretty sure the vent was framed in wood. I'll have to pull the trim down...
|
Forum: Lite Weight Trailers
08-23-2022, 07:05 AM
|
Replies: 25
Views: 6,274
Well I wish I had thought of your suggestions...
Well I wish I had thought of your suggestions earlier. I put a level across the area and it is indeed lower. The door starts out about 2 3/4" from the ceiling, hits the light at about 1 3/4" from the...
|
Forum: Lite Weight Trailers
08-23-2022, 06:25 AM
|
Replies: 25
Views: 6,274
Bullet 22RBI - bathroom door hits ceiling light
I'm curious as to what has caused this or if I should really care.
I had always wondered why the top of my bathroom door was a couple of inches lower than the door opening. It turns out it's so...
|
Forum: Lite Weight Trailers
04-29-2022, 11:26 AM
|
Replies: 32
Views: 25,597
|
Forum: General RV Issues
11-15-2021, 10:46 AM
|
Replies: 8
Views: 2,935
|
Forum: General RV Issues
11-15-2021, 07:24 AM
|
Replies: 8
Views: 2,935
|
Forum: General RV Issues
11-15-2021, 07:10 AM
|
Replies: 8
Views: 2,935
Winterizing Question - Pump not building pressure
Hi all -
I was winterizing my new-to-me Bullet over the weekend. I used the same method that I did on my previous rig. Blew out the lines then hooked a garden hose up to the water pump inlet to...
|
Forum: Travel Trailers
10-20-2021, 06:57 AM
|
Replies: 15
Views: 7,612
Everyone has pretty much answered the question...
Everyone has pretty much answered the question but I figured I'd chime in. My previous rig had the same option for heat. I did the research and arrived at the conclusion that it wasn't worth the...
|
Forum: Keystone Questions
10-20-2021, 06:39 AM
|
Replies: 26
Views: 5,369
|
Forum: Lite Weight Trailers
10-17-2021, 08:55 AM
|
Replies: 32
Views: 25,597
|
Forum: Lite Weight Trailers
10-17-2021, 04:32 AM
|
Replies: 32
Views: 25,597
|
Forum: Lite Weight Trailers
10-11-2021, 08:47 AM
|
Replies: 32
Views: 25,597
What did you use on the seams? Lap sealant or...
What did you use on the seams? Lap sealant or EPDM coating (or neither)?
Also, did the factory use butyl tape along the seams and roof protrusions? I have it everywhere. Seems primitive (like...
|
Forum: Lite Weight Trailers
10-11-2021, 05:37 AM
|
Replies: 32
Views: 25,597
Nice work! Unfortunately after looking at your...
Nice work! Unfortunately after looking at your pictures I'm 100% sure I have this issue on my '15. The "sun damage" that the previous owner alleged must be the particle board swelling. I don't really...
|
Forum: Repairs & Maintenance
09-19-2021, 09:19 AM
|
Replies: 8
Views: 5,464
|
Forum: Repairs & Maintenance
09-19-2021, 09:06 AM
|
Replies: 14
Views: 5,538
Okay - a quick update.
The new 30-amp plug I...
Okay - a quick update.
The new 30-amp plug I put on the end of the 10-gauge cord melted as well.
So I got looking at it and realized I had been overlooking something obvious. After the first...
|
Forum: Lite Weight Trailers
09-19-2021, 09:03 AM
|
Replies: 32
Views: 25,597
Yeah mine looks "wavy" across the top, with the...
Yeah mine looks "wavy" across the top, with the worst of it on the left corner where it almost looks like something fell on it (but it didn't - it's just warped). Inside, in the same spot, it looks...
|