Installing a Washer/Dryer in the Alpine

[DocData757]

We've been planning on installing a Washer/Dryer combo in our 2011 Alpine since we got it. We've got the money and, fortunately, a question came to mind about the installation.

I checked the dimensions listed on several websites and the unit has a 23 -1/2" by 23-3/8" footprint.

The bedroom door is 23" wide! It looks like I have to pull the wood molding off the inside of the door frame, remove the door, hinges and latch and then remove the plastic door frame to get about a inch more of clearance.

Anyone done this?

Thanks,

[DocData757]

Ok, no one seems to have any idea. I will proceed by removing the molding and then the plastic door frame.

Here's another question... I will have to cut a 4" hole though the side wall for the vent. To anyone with a water/dryer vented combo.... where does your vent penetrate the wall? Down by the floor? Up about the washer?

Thanks,

[Hunter757]

Here is a picture of one I found online. It looks to be just above the door in the picture. I hope this helps you out not even sure if that is the vent or not but it sure looks like it. Nice fiver wow.

[jq1031]

My previous RV had the vent coming out high, maybe a foot below the roof line.

[mikell]

The dryer vent would be a lot farther to the front than that