PDA

View Full Version : Electrical Schematic


Glenn S
08-25-2019, 07:55 AM
Trying to label my terminals where the wires land on a 2017 keystone.
Tried to find a wiring drawing , but no luck.

chuckster57
08-25-2019, 08:22 AM
Not sure how far back this applies, As a rule wiring diagrams are not published. And even if they are, I have found over the years NOT to trust the labeling.

https://www.keystonerv.com/upper-navigation-pages/community/krv-blog/content-container/keystone-innovation-wired-for-performance/

We still use an Ohm meter and pull fuses..

Glenn S
08-25-2019, 08:38 AM
Thanks chuckster57. I did print out that wire color pages.
Will go back and plug fuses one at a time.

CaptnJohn
08-25-2019, 08:45 AM
During assembly employees do not have a diagram.

travelin texans
08-25-2019, 09:37 AM
During assembly employees do not have a diagram.

And most couldn't read them if they did.
They run the wiring the shortest distance between points A & B with whatever wire is left waded up in the middle of a cabinet so that space is then unusable.

CaptnJohn
08-25-2019, 01:35 PM
And most couldn't read them if they did.
They run the wiring the shortest distance between points A & B with whatever wire is left waded up in the middle of a cabinet so that space is then unusable.



I was going to say the same but being overly nice for an hour today. [emoji106]